プラスチック光ファイバ中のモード間干渉を用いた歪・温度センシングに関するこれまでの研究展開をまとめた水野助教の招待総説論文が IEICE Transactions on Electronics に掲載されました。
Y. Mizuno, G. Numata, T. Kawa, H. Lee, N. Hayashi, and K. Nakamura, “Multimodal interference in perfluorinated polymer optical fibers: Application to ultrasensitive strain and temperature sensing,” IEICE Trans. Electron., vol. E101-C, no. 7, pp. 602-610 <invited review>.
We review the recent advances on strain and temperature sensing techniques based on multimodal interference in perfluorinated (PF) graded-index (GI) polymer optical fibers (POFs). First, we investigate their fundamental characteristics at 1300 nm. When the core diameter is 62.5 μm, we obtain strain and temperature sensitivities of –112 pm/με and +49.8 nm/˚C, the absolute values of which are, by simple calculation, approximately 13 and over 1800 times as large as those in silica GI multimode fibers, respectively. These ultra-high strain and temperature sensitivities probably originate from the unique PF polymer used as core material. Subsequently, we show that the temperature sensitivity (absolute value) is significantly enhanced with increasing temperature toward ~70°C, which is close to the glass-transition temperature of the core polymer. When the core diameter is 62.5 μm, the sensitivity at 72°C at 1300 nm is 202 nm/°C, which is approximately 26 times the value obtained at room temperature and >7000 times the highest value previously reported using a silica multimode fiber. Then, we develop a single-end-access configuration of this strain and temperature sensing system, which enhances the degree of freedom in embedding the sensors into structures. The light Fresnel-reflected at the distal open end of the POF is exploited. The obtained strain and temperature sensitivities are shown to be comparable to those in two-end-access configurations. Finally, we discuss the future prospects and give concluding remarks.